Coates 2-component pad printing inks

For cellulose acetate, duroplastics, polyamide, polyester, polyacetal (post-treated), pre-treated polyethylene and polypropylene, metals and coated surfaces (also for 2-component systems and powder-coated surfaces).

TP 218-NT inks are quick drying, glossy and opaque. They show high mechanical resistance and resistance against many organic solvents, chemicals, diluted alkalines and acids, oils and grease.

For glass, duroplastics, ceramics, metals including chromium and nickel-plated, gilded or rhodium coated surfaces.

Pad printing inks TP 218-GL-NT can be air-dried or oven-cured. They result in a semi-gloss finish of good opacity. TP 218-GL-NT inks show high mechanical resistance and resistance to many organic solvents, chemicals, thinned alkalines and acids, oils and grease.

Excellent water resistance is achieved with hardener TP 219/GL and air drying. Resistance to various solvents, however, is limited.

Resistance to water and chemicals can be improved considerably with the use of hardener TP 219/03-GL. TP 219/03-GL air dries or cures by heat application within 20 minutes at 140°C. Using hardener TP 219/02-GL and oven-curing at 140°C for 20 minutes.

For duroplastics, glass, coated surfaces, metals and non-ferric metals, polyamide, polycarbonate, polyester, polymethacrylate, polyurethane and rigid PVC.

TP 260-NT inks are quick drying, glossy pad printing inks. They show resistance to many organic solvents, chemicals, diluted alkalines and acids. Resistance to mechanic abrasion is very good.

For printing onto pre-treated polyolefines such as polyethylene and polypropylene, thermoplastics (ABS, acrylics), metals, duroplastics and epoxy resins.

2-component pad printing inks TP 307-NT are glossy, show good opacity and high chemical and outdoor resistance.